After the above calculation we got the net seedlings (net pocket above part of the commonly known as seedlings) length, according to their length requirements after weaving the net seedlings, you should expect the net pocket, the last eye-care part of the next called Net bag, net bag weaving is not complicated, without eye health. However, it is required to knot nets to play strong and flat, try to avoid the knot, squint appears, so some woven nets required speed is slower, the net pocket length of not less than 80cm is best weave to 1m. Because from the eye down but also leave 10 ~ 20cm Pu water (Pu water is a common saying, refers to the net part of the net when there is enough space close to the bottom, to avoid fish paste to escape) Need to emphasize that the net pocket The line must be strong and durable, the best selection of thicker tire line, because part of the net fishing is a key part of fishing, net bag is not strong and damaged will cause the running fish.
The closure is the process of fixing a lead pendant (commonly known as a reef) to a fishing net with a rope. Seal the quality of a direct impact on the size of the fishing nets and fishing rates, fishing net closure over the tight mesh is difficult to fully open, the seal is too loose and easy to run fish, so before the closure of fishing nets have to be calculated, we usually The single mesh into a square, and then use the Pythagorean theorem to calculate the length of the diagonal, and then calculate the last circle of the number of mesh Finally, calculate the last round of mesh in the square of the diagonal length of the sum, draw the net The length of the rope, and then divided by the number of net bags to be sealed is the length of each net pocket. After all the calculations, the first step is to wear the mesh rope with two mesh seals, and one S is passed through each of the last meshings. The rope that is passed through the mesh is called the mother rope. The other rope is called a child rope, the mother rope than the child rope to the general diameter of about 0.5 or polyester or polypropylene, so soft and hard rope moderate, strong and durable, with about 0.3 strand on it.
The length of the bus bar should be three to five meters to calculate the total length of the net bag. The length of the strand should be double that of the calculated length. The child bus bar needs to be bent and knotted during the process of sealing, consuming a lot of length Avoid the net rope is not long enough.
Each net bag has 4 to 6 lead pendants, lead pegs connected by the child bus, with 32 net nets per net, requiring 128 lead pegs (four lead pendants per pocket).
Before starting to seal the net, we should look for the eye of a strip as the center of the two net bags and the last net of the eyes extend as the central net between the two lead pendants to make the sling even more beautiful at the later stage. Tightly wrapped around the big shuttle, find out the first need to plummet a fixed mesh, in the left of the mesh between the child with a rope tied to the parent rope, tightened, take a lead to the first A mesh top to the cross on the knot, the right hand take the child rope around the lead after the snake wound around the front and then with the child rope cross knot to the left side of the left lead plum, the same way with the bus cross knot implants Need a fixed mesh, the cross in the big cross, so that the cable is fixed to the lead above the pendants, and then set aside a good calculation of the distance between the plumper Repeat the above operation, the pendants were one by one fixed to the Internet. Is a lead plumper on each cross must be tightened, and to be stuck in the gap on both sides of the lead plumper.Left cross at both ends of the cross to Le very tight lest the lead fall off, cross knot must hit a small, to avoid Use when hanging network cable, in addition, we must make the lead fall The picture rope length symmetry, or will cause uneven force when the net result of the nets Zhang is not round.
Finally, the nets must be handled properly when the nets are sealed, generally tied to the last lead on the lead, and tied up with a thin wire to avoid opening and hanging nets.
After the lead plugs have been sealed, a fishing net has been basically formed. At this time, the nets should be further trimmed. Use scissors to cut off excess threads. It is advisable to use 502 glue to bond the joints to prevent the knotting.
Department of Fork line, Fork line is used to carry the net pulling force of the line, wrapped a shuttle thinner tire line to find the last eye, the number of the next few three mesh to the bottom of the third network mesh top , V-shaped extension to the fifth network node, followed by around the fifth and third knot knot and the first knot just above the third knot, thus forming a fork structure fork structure.